![]() The only thing I am using that might be considered altered controls is the legacy cart steering and that's it. This happens regardless of if I press the up, down, or stop buttons on either the elevator itself or the call buttons.Īnd I have not altered my controls at all from the defaults. ![]() The UI I am referring to is the standard, tabbed UI that pops up for nearly any workstation you interact with, the tabs in this case being the Authorization and Status tabs. Is there some way to interact with the elevator and the call buttons that doesn't make the UI also pop up every time? I couldn't wait to get access to this, but now it is more of a hassle to use than a help. And since the elevator doesn't seem to automatically stop at a floor with a call button, I have to press 'E' again to stop it where I want it, which also brings up the UI. This is quite annoying and useless and just interferes with me using the elevator as I have to close the UI after every button press. My issue is the button to operate the call buttons and the elevator is the same to open the damn UI thing, which is 'E'. I have a call button at every floor to call it to that floor as well. It goes up and down from top to bottom and vice versa without issue. I figured out how to suspend the elevator over the side of my currently four floor workshop structure. I just got to the point where I can make the wooden elevator on the assembly line and call buttons on the sawmill.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |